Hammer-Set™ Anchors

Description/Advantages

The Hammer-Set one-piece zinc plated steel anchor consists of an expansion body and expander drive pin. Anchors meet or exceed GSA specification A-A-1925A Type 1. (Formerly GSA: FF-S-325 Group V, Type 2, Class 3)

Fast, easy installation
Works in concrete, block and brick
Install through material to be fastened
Low profile mushroom head style

Applications

NOT FOR USE IN OVERHEAD APPLICATIONS*

* For overhead applications refer to page RH 71 for Redi-Drive information and performance data

Electrical boxes

Conduit clips

Drywall track

Roof flashing

Installation Steps

	1. Drill proper size hole through material to be fastened into base material. (See Chart for bit size).
	2. Clean hole.
	3. Insert Hammer-Set into hole until head of anchor body is flush with material to be fastened. Tap the nail until flush with head of anchor. Ensure minimum embedment is 1/4" deeper than anchor embedment. Be sure head is firmly against fixture.
	4. Anchor is now set. NOT RECOMMENDED FOR OVERHEAD