Screen Tubes
Description/Advantages
HBP SERIES—NYLON SCREENS
- 30%-50% savings from stainless steel screens
- Comparable per formance values
- Easier to insert and span across voids
- Flexible material is less susceptible to damage from crushing
HB SERIES—STAINLESS SCREENS
- Corrosion resistant
- Available in 1/4" to 3/4" diameters
- Special version, “dosage control” available for overhead and under water installations
 |
1. Drill hole to the length of the screen plus 1 diameter, using rotation-only drilling mode. Clean out hole with forced air. Complete hole preparation with use of a brush and repeat cleaning with forced air (leave no dust or slurry). |
 |
2. When starting new cartridge or new nozzle, dispense and discard enough adhesive until uniform adhesive mix is achieved. Insert the nozzle into the bottom of the screen and fill screen completely full (use extension tube if needed to reach bottom of screen). |
 |
3. Insert the filled screen completely intoMaterial Screens the hole (subflush). |
 |
4. While holding the tab of the screen against the wall, hand insert the selected rod slowly into the screen tube with a slow twisting motion. Pull screen flush to face and coat with adhesive. Wait for appropriate cure time before torquing fixture in place. |